Asgard V2
Post added on Sept. 8, 2019
Asgard V2
AIO Flight Controller and 4 pcs. BLHELI_S ESC on one PCB, mounting hole 30.5 x 30.5mm. Incl. OSD / SD Card / F4 FC(Target OMNIBUS F4 SD) / Current sensor / BEC
The on board ESC supports DSHOT, use J_H_15 firmware
ESC tested under 3-4S, 2308 Motor 2300KV with 5045x3 props The actual current depends on the frame and air flow
| Specifications | |
|---|---|
| Product type | Flight controller - Electronic speed controller (ESC) |
| Brand | Airbot |
| ESC type | 4 in 1 |
| Firmware upgrade | BLHELI_S - JESC |
| Protocol compatibility | PWM - ONESHOT 125 - DSHOT 300 - DSHOT 600 - MULTISHOT |
| Voltage (volt) | 7.4 - 11.1 - 14.8 |
| Amperage (A) | 25 |
| Processor | STM32F405RGT6 |
| Gyroscope | SPI Gyro MPU6000 |
| Accelerometer | SPI Gyro MPU6000 |
| Blackbox | Supports MicroSD Card |
| On-screen display (OSD) | On-board OSD (over SPI Bus) |
| Current sensor | Built-in |
| Voltage sensor | Built-in |
| Voltage regulator (BEC) | 5V 1A |
| Number of UART ports | 3 |
| Length (millimeter) | 30 |
| Width (millimeter) | 49 |
| Height (millimeter) | 8 |
| Cable connector | Solder pads - JST-SH |
| Mounting hole pattern | 30.5x30.5mm |
| Mounting hole diameter (millimeter) | 3 |
| Light-emitting diode (LED) | Solder pads - JST-SH |
| Buzzer | Solder pads - JST-SH |
| USB connector | USB Micro B |
| Radio receiver protocol | SBUS - DSM2/DSMX (Spektrum Satellite) - IBUS - CRSF (TBS Crossfire) |
| Weight (gram) | 18 |
